USE AND CARE MANUALFor Model FS87PHLPStop! Missing a part? DO NOT RETURN PRODUCT TO STOREThe store where you made the purchase does not stockparts for
Assembly Process10Step 5 - Attach Reector Studs to Screen CoverInsert 3 Reector Studs & 3 large Flat Washers.Tighten studs securely.3 Reector S
Assembly ProcessStep 7 - Install Reector▲! WARNINGRemove protective lm before assemblyNote: It is necessary for proper alignment of reflector s
Assembly Process12Slide one Small Flat Washer over threaded end of screw and loosely screw on Cap Nut. Repeat procedure to complete the assembly o
Assembly Process13Step 8 - Attach Reector Assembly to StudsSupport Heater.Slide 3 Large Flat Washers over threaded end of Studs.Install Reector Asse
Step 9 - Connect Hose & Regulator to CylinderSpecications- You must provide propane gas and propane cylinder. Use a standard 20 lb. Propane cy
Gas RequirementsL.P. GAS INSTALLATIONGas Heaters that are set to operate with L.P. gas come with a high capacity hose and regulator assembly. (Note: O
Pre-Operation Leak TestingGENERAL INFORMATIONAlthough all gas connections on the heater are leak tested prior to shipment, a complete gas tightness ch
OperationDo not attempt to "Light" the Heater if the odor of gas present!!LIGHTING:Note: This heater is equipped with a Pilot light that all
Operation18If for some reason your igniter fails to deliver a spark, your heater can be started by inserting a lit match through the pilot view hole w
Care and MaintenanceTo enjoy years of outstanding performance from your heater, make sure you perform the following maintenance activities on a regula
General Safety Instructions... Components & Hardware...
Troubleshooting 20BEFORE CALLING CUSTOMER SERVICEIf the heater does not function properly, use the following checklist.If the problem is:
LIMITED WARRANTYSure Heat Mfg warrants that the components of this appliance are warranted free from defects in material and workmanship for one year
General Safety InstructionsIMPORTANT SAFETY INFORMATION - This manual contains important information about the assembly, operation and maintenance of
General Safety InstructionsFOR YOUR SAFETYDO NOT store or use gasoline or other fl ammable vapors and liquids in the vicinity of this or any other appl
General Safety Instructions▲! DANGER CARBON MONOXIDE HAZARD- This heater is a combustion appliance. All combustion appliances produce
Components & Hardware1234567891011126Reector Panel (3)Reector PlateReector AssemblyReector Stud (3)Heater Burner ScreenHeater AssemblyCylinde
Components & Hardware7Additional RequirementsThe following items are not included, but are necessary for the proper assembly of your heater. DO N
Assembly Process8Line up holes in Wheel Bracket with corresponding holes in base. Insert 2 Medium bolts through holes and nger tighten the 2 Larg
Assembly Process9Step 3- Attach Cylinder Housing to BaseAttach Cylinder Housing loosely to Base with four Small Screws.Step 4- Attach Post to Cylinder
Kommentare zu diesen Handbüchern